DigiDesign 192 I/O Spécifications télécharger pdf (Page 17)

Appendix A: Card Removal and Replacement 13

10 Gently push the cable connector into the

card’s connector. The ridge on the cable connec-

tor must be line directly into the groove on the

card connector. Be very careful not to bend any

of the pins.

11 Place the top cover onto the 192 Digital I/O

and replace the screws that you removed with it.

12 Connect the 192 Digital I/O to your

Pro Tools|HD system.

13 Press the Power switch.

14 When you power on the unit, the power LED

should turn orange.

15 Start up the computer.

16 When you boot up the computer, the ring

LEDs around the 192 Digital I/O power should

turn from orange to green. (If this does not oc-

cur, see “Troubleshooting” on page 13.)

17 Launch Pro Tools.

18 Choose Setup > Hardware. If the new card

does not appear in the Hardware Setup dialog,

power down, check the seating of the card, and

recheck the cables inside the 192 Digital I/O.

Troubleshooting

◆ If the ring of LEDs around the power switch

does not turn from orange to green the com-

puter is started, make sure you reconnected the

DigiLink cable to the Primary port on the rear of

the unit.

◆ If the DigiLink cable is securely fastened and

the other end is plugged into a Pro Tools|HD

card, you may have inadvertently disconnected

another 50-pin cable when installing the card.

Hardware Setup Changes

Whenever a card is removed or replaced, the

Hardware Setup I/O routing reverts to original

defaults.

Pressing the 50-pin cable connector into the card

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23

Commentaires sur ces manuels

Pas de commentaire