DigiDesign HD MADI Guide de l'utilisateur télécharger pdf (Page 25)

Known issues

Start up errors

When the Pro Tools

software starts up, it uses the settings defined during the previous session, e.g. number and type of Audio

Interfaces, I/O setup, etc.

If you have used a Legacy Audio Interface (defined through menu: Setup|Hardware), and then replaced its current Audio

Interfaces with the Delta-Link MADI HD, the Pro Tools

software will display the following error message: “DAE error -1125

was encountered”. This is because the Legacy Audio Interface cannot be detected anymore. After clicking “OK”, the Pro Tools

software will close without allowing you to change the Hardware setup!

Solution 1. (Mac or PC)

• An easy way to get around this problem is to startup Pro Tools

with the Delta-Link MADI HD switched OFF. The

following message will eventually be displayed: “Unable to find an Audio Interface attached to..”. At this point, power

up the Delta-Link MADI HD and click “OK”. Pro Tools

will then continue its start up procedure.

Solution 2. (Mac Only)

• Another way to solve this problem is to delete the “DigiSetup.OSX” file and the “DAE prefs” folder in the

“Library/Preferences” folder. This will force Pro Tools

to start up using a default configuration (48kHz, limited

“Voices”, no Hardware knowledge...)

For either solution, now go to menu:

Setup|Hardware and make sure all Legacy Interfaces are removed from the Peripherals

list (see over leaf).

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32

Pas de commentaire

DigiDesign HD MADI Guide de l'utilisateur Page 25