DigiDesign Focusrite d3 Spécifications télécharger pdf (Page 27)

Chapter 4: Focusrite D3 23

Release

Release controls how long it takes for the com-

pressor to be fully deactivated after the input

signal drops below the threshold level. In gen-

eral, this setting should be longer than the at-

tack time and long enough that if signal levels

repeatedly rise above the threshold, they cause

gain reduction only once. If the release time is

too long, a loud section of the audio material

could cause gain reduction that persists through

a soft section. The range of this control is from

25 milliseconds to 2.5 seconds.

Auto Release

Auto Release enables the automatic release func-

tion. In this mode the Release control has no ef-

fect on release time. Instead, the D3 uses a re-

lease time value that is program dependent and

based on the audio being processed.

D3 Limiter Controls

The Limiter icon, which represents a limiter

curve, acts as a three-state switch for enabling,

disabling, or bypassing the limiter. Its current

state is indicated by the icon’s color:

• White indicates enabled. In this state, the

limiter is active and using available DSP re-

sources.

• Black indicates disabled. In this state, the

limiter is not using DSP resources.

• Gray indicates bypassed. In this state, the

limiter is not active, but is still using avail-

able DSP resources.

To disable the limiter:

■ Start key-click (Windows) or Control-click

(Mac) the icon. When the limiter is disabled, the

icon is black.

To re-enable the limiter:

■ Click the icon. When the limiter is enabled,

the icon is white.

Auto Release

Auto Release

Limiter controls

Limiter In/Out icon

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 38 39

Commentaires sur ces manuels

Pas de commentaire