DigiDesign Control 24 Spécifications télécharger pdf (Page 147)

Appendix B: Utility Functions 137

Cycle Test Mode

Cycle test mode places the faders on Control|24

in a test mode where the faders cycle, lock-step,

from the bottom of the fader throw to the top in

a continuos cycle. The speed at which the faders

cycle is determined by adjusting the scrub/shut-

tle wheel.

When “Cycl” fader test mode is engaged:

• The encoder switch LED located below the

scribble strip which shows “Cycl” will light

solid indicating that this is the chosen test

mode.

• All other display test menu items shown on

the scribble strips as well as their associated

ﬂashing encoder switch LEDs, will remain vis-

ible in this test mode.

• The scribble strip displays will toggle back and

forth between the cycle values, which allows

you to select another display test mode with-

out the need to ﬁrst “Exit” this mode.

• The fader position value will be shown in

these scribble strips and will be updated in

real-time as the faders “cycle.” Values will

range from off (value of “0000”) to full-on

(value of “1023”).

• Rotate the scrub/shuttle wheel to adjust the

cycle speed that the faders use. Turning the

wheel to the left decreases the speed while ro-

tating the wheel to the right increases the

speed.

• Press the ﬂashing encoder switch located be-

low the scribble strip showing another test

mode to simultaneously disengage the fader

cycle test mode and enter the newly selected

mode. The encoder switch LED for the new

choice will light solid while the other choices

ﬂash.

• When ﬁnished, press EXIT.

Sine Test Mode

Sine test mode places the faders on Control|24

in a test mode where the faders cycle, in a sine

wave shape, from the bottom of the fader throw

to the top. The speed at which the faders cycle is

determined by adjusting the scrub/shuttle

wheel.

When “Sine” Fader Test Mode is Engaged:

• The encoder switch LED located below the

scribble strip which shows “Sine” will light

solid indicating that this is the chosen test

mode.

• All other display test menu items shown on

the scribble strips as well as their associated

ﬂashing encoder switch LEDs, will remain vis-

ible in this test mode. The scribble strip dis-

plays will toggle back and forth between the

sine cycle values, to allow you to select an-

other display test mode without the need to

ﬁrst “Exit” this mode.

• The fader position value will be shown in

these scribble strips and will be updated in

real-time as the faders cycle in sine mode. Val-

ues will range from off (value of “0000”) to

full-on (value of “1023”).

• Rotate the scrub/shuttle wheel to adjust the

cycle speed that the faders use. Turning the

wheel to the left decreases the speed while ro-

tating the wheel to the right increases the

speed.

• Press EXIT, or press the ﬂashing encoder

switch located below the scribble strip show-

ing another test mode to simultaneously dis-

engage the fader sine test mode and enter the

newly selected mode. The encoder switch LED

for the new choice will light solid while the

other choices ﬂash.

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 158 159

Commentaires sur ces manuels

Pas de commentaire