DigiDesign Control 24 Spécifications télécharger pdf (Page 57)

Chapter 7: Overview and Basics 47

To enter an amount of pre- or post-roll:

1 While pressing the (CTL) switch, press PRE

ROLL or POST ROLL. The respective switch LED

(PRE or POST) will ﬂash, indicating that pre/post

entry mode is active.

2 Type values for pre-roll or post-roll using the

numeric keypad. Press the Control|24 PREVI-

OUS or NEXT switches to tab through the nu-

meric ﬁelds.

3 Press ENTER to set the time values. Press

ESC/CANCEL to cancel changes.

To deﬁne selection in and out points during

playback:

1 Make sure AUDITION is off.

2 While Pro Tools is playing, press IN to deﬁne

selection start, then press OUT at the desired se-

lection end.

Audition Mode Functions

The AUDITION switch toggles Audition mode

on and off. When its LED is lit, playback can be

controlled from the PRE ROLL, IN, OUT and

POST ROLL switches.

PRE ROLL Plays audio starting at the pre-roll

point up to the beginning of the selection.

IN Plays audio starting at the selection start

through the length of the post-roll amount.

OUT Plays audio back-timed from the selection

end by the pre-roll amount.

POST ROLL Plays audio from the end of a selec-

tion by the post-roll amount.

Audition Mode Shortcuts

To listen to the edit selection start point with both

pre- and post-roll:

■ While pressing (CTL)+OPT(ALT)/ALL, press

PRE or IN.

To play edit selection end with pre-and post-roll:

■ While pressing (CTL)+OPT(ALT)/ALL, press

OUT or POST.

Transport Control of External Devices

Using the EXT TRANS switch, Control|24 can

toggle between Pro Tools or your external de-

vice as the transport master or slave.

To select the Transport Master:

1 Configure Pro Tools and your external device

for synchronization (see the Pro Tools Reference

Guide, SYNC I/O Guide, or MachineControl Guide

for more information).

2 Hold CTL/CLUTCH while pressing

EXT TRANS. This cycles through all currently

available choices for machine transports. As you

change the transport master, the scribble strips

display the message, “Transport now controls

ADAT,” or “Transport now controls Serial Ma-

chine.”

3 When the desired transport is selected, release

CTL/CLUTCH to save the setting.

To toggle the Transport Master:

1 Press EXT TRANS to toggle between the se-

lected device and Pro Tools as the transport mas-

ter.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 158 159

Commentaires sur ces manuels

Pas de commentaire

DigiDesign Control 24 Spécifications Page 57

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel d'enregistrement DigiDesign Control 24